We having wide production range of Cooling Tower motor 0.25 H.p. to 20 H.p. (0.18 K.W. to 15 K.W.) Frame 63 to 225M in 4, 6, 8, 10 & 12 Pole (1500, 1000, 750 , 600 and 500 RPM at 50 Hz.).

– Flange (B5)

All Cooling Tower Motor are supplied in a robust, rugged cast iron frame.

All Cooling Tower Motors are continuous (S1) rated to comply with performance standards.

Cooling Tower Motor Supply volts 415 ± 5% 3 phase 50 Hz. ± 3% We are also capable for Manufacturing three phase motor in different volts and frequency Like 220, 380, 460, 525.

We are Providing Cooling Tower Motor with IP55. Motor relative humidity up to 90%.

Cooling Tower Motor Shaft is Mead by stainless steel material AISI-410. Nut and washer are made for stainless steel AISI-202. It can make protection against corrosion. Motor shaft extended so cooling fan fitted properly.

Insulation class “F” with constant duty (s1) Cooling tower motor design for Working S1 Duty. For continues working.

Oil Seal fitted with Flange & Shaft so that out of reach water partial or moisture inside a motor. Bearings are double shielded (ZZ or 2RS) and pre-lubricated with high temp grease for good life of bearings.

All Cooling Tower motor Supply with Enclosure T.E.S.C. (Totally Enclosed surface Cooled)

We can also supply motor with T.O.P Switch on Demand of Customer. . It can provide motor extra safety form over lord protection.

All Cooling Tower Motor provided with minimum two earthling terminals. One in the terminal box and other out side on Body.

Cooling Tower motor are painted with semi glossy synthetic enamel paint. However sp. Paint is available on request.